flashrom v1.2-882-g6a3988b on Linux 5.16.10-051610-generic (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
flashrom was built with GCC 9.4.0, little endian
Command line (7 args): ./flashrom -p dediprog -c MT25QL512 -r backup.bin -VVV
Initializing dediprog programmer
Found USB device 0483:dada at address 1-24.
Using dediprog id SF119907.
Found a SF100   V:6.5.03
SPI speed is 12MHz
Setting SPI voltage to 3.500 V
The following protocols are supported: SPI.
Probing for Micron MT25QL512, 65536 kB: programmer_map_flash_region: mapping MT25QL512 from 0x00000000fc000000 to 0x0000000000000000
dediprog_spi_send_command, writecnt=1, readcnt=3
RDID returned 0x20 0xba 0x20. compare_id: id1 0x20, id2 0xba20
Added layout entry 00000000 - 03ffffff named complete flash
Found Micron flash chip "MT25QL512" (65536 kB, SPI) on dediprog.
dediprog_spi_send_command, writecnt=1, readcnt=2
Chip status register is 0x00.
Chip status register: Status Register Write Disable (SRWD, SRP, ...) is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Top/Bottom (TB) is top
Chip status register: Block Protect 2 (BP2) is not set
Chip status register: Block Protect 1 (BP1) is not set
Chip status register: Block Protect 0 (BP0) is not set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
programmer_unmap_flash_region: unmapped 0x0000000000000000
This chip may contain one-time programmable memory. flashrom cannot read
and may never be able to write it, hence it may not be able to completely
clone the contents of this chip (see man page for details).
programmer_map_flash_region: mapping MT25QL512 from 0x00000000fc000000 to 0x0000000000000000
dediprog_spi_send_command, writecnt=1, readcnt=2
Block protection is disabled.
dediprog_spi_send_command, writecnt=1, readcnt=0
dediprog_spi_send_command, writecnt=1, readcnt=0
Reading flash... done.
programmer_unmap_flash_region: unmapped 0x0000000000000000
Setting SPI voltage to 0.000 V